Course Content
Clinical Measures
Clinical measures are taken by the prescribing Podiatrist during a consultation. Certain measurements are required for the design of a well balanced orthotic device. In this topic we will discuss: Scan Angle, Forefoot Varus, Forefoot Valgus and other measurements.
0/3
Scan Angle
Forefoot Varus
Forefoot Valgus
Shoe Fitting
Explains the features found in the Shoe Fitting section of OBD's prescription software.
0/6
Shoe Sizing Charts
Sneaker Grind
Plantar Grind
45° Cutout
Shoe Fit Options
Additional Options
Intrinsic Adjustments
Defines and explains the meaning of the Intrinsic Adjustments section in OBD's prescription software.
0/8
Plantar Fascia Accomodation (PFA)
Medial and Lateral Arch Fill
Medial and Lateral Rear Foot Posting (RF Posting)
Inversion and Eversion Ramping
Heel Cup Adjustments
Intrinsic Heel Lift
Metatarsal Wedging
Skives
Off Loading
Explains the features found in the Off Loading section of OBD's prescription software.
0/6
Cuboid Raises & Dells
Styloid Raises & Dells
Navicular Raises & Dells
Apertures
Poron U-Pads
Metatarsal Domes & Pads
Device Options
Explains the various features you can utilise in your orthotics - found in the Device Options section of OBD's prescription software.
0/4
Intrinsic Options
Extrinsic Options
Extension
Custom Shaping
Materials
Explains the varying base block, mid layer and top cover materials available for selection in OBD's prescription software.
0/1
Materials Overview
Prescription Training

Inversion & Eversion Ramping

An Inversion Ramp is an intrinsically applied medial wedge applied within the area of application.

The default value is 0° degrees with a maximum ramp of 45°.

Area of Application:

 

This area of application can be easily modified during computer-aided design. The best practice is to mark the required area of application directly on the foot prior to 3D colour scanning or plaster casting. If this is not possible, then you can simply draw a diagram using the Make Drawing tool.

 

An Eversion Ramp is an intrinsically applied lateral wedge applied within the area of application.

 

Lateral wedging lengths can be set as the below combinations:

Previous
Next